Switch Setup Step-by-Step

CCNA 200-301 LABS OUTLINE

• Cisco Command-Line Interface (CLI
• Observe How a Switch Operates and perform basic Switch Configuration
• Implementation of the Initial Switch Configuration
• Inspect TCP/IP Applications
• Configure an Interface on a Cisco Router
• Configure and Verify Layer 2 Discovery Protocols
• Implement an Initial Router Configuration
• Configure Default Gateway
• Explore Packet Forwarding
• Troubleshoot Switch Media and Port Issues
• Troubleshoot Port Duplex Issues Configure Basic IPv6 Connectivity
• Configure and Verify IPv4 Static Routes
• Configure IPv6 Static Routes
• Implement IPv4 Static Routing
• Implement IPv6 Static Routing
• Configure VLAN and Trunk
• Troubleshoot VLANs and Trunk
• Configure a Router on a Stick
• Implement Multiple VLANs and Basic Routing Between the VLANs
• Configure and Verify Single-Area OSPF
• Configure and Verify EtherChannel
• Improve Redundant Switched Topologies with EtherChannel
• Configure and Verify IPv4 ACLs
• Implement Numbered and Named IPv4 ACLs
• Configure a Provider-Assigned IPv4 Address
• Configure Static NAT
• Configure Dynamic NAT and Port Address Translation (PAT
• Implement PAT
• Log into the WLC
• Monitor the WLC
• Configure a Dynamic (VLAN) Interface
• Configure a DHCP Scope
• Configure a WLAN
• Define a Remote Access Dial-In User Service (RADIUS) Server
• Explore Management Options
• Explore the Cisco DNA™ Center
• Configure and Verify NTP
• Configure System Message Logging
• Create the Cisco IOS Image Backup
• Upgrade the Cisco IOS Image
• Configure WLAN Using Wi-Fi Protected Access 2 (WPA2) Pre-Shared Key (PSK) Using the GUI
• Secure Console and Remote Access
• Enable and Limit Remote Access Connectivity
• Secure Device Administrative Access
• Configure and Verify Port Security
• Implement Device Hardening